Petersfield Framing StudiosPetersfield Framing Studios

Please visit our other website for everything professional framing Petersfield Framing Studios.

ContactContact Us

Tel: 01730 269926
or This e-mail address is being protected from spambots. You need JavaScript enabled to view it.
or use our Contact page >

OpeningOpening Times

Mornings - Monday to Friday from 9.00am to 1.00pm

Afternoons - by appointment only

ContactVisit Us

Petersfield Framing Studios
Unit 4A
Buriton Business Park
Petersfield, Hants
GU32 3NJ

 

Mount Cutting & Multiple Aperture Mounts

This page provides a summary of how best to use the mount cutter that I recommend. It also forms a summary of the instructions that I have written to go with the mount cutter. The instructions for the mount cutter are made up of 12 pages of A4 and utilise a step-by-step approach. There are also useful diagrams throughout so guide you along the way. The mount cutter used here is a Jakar mount cutter and can be purchased through this website. Please visit our Shop for further details.

Useful Tips for Mount Cutting

Cutting Mount

Make sure the mount cutter is this way round

  1. Make sure that the mount cutter runs up and down the straight edge groove smoothly.
  2. Check that the blade is sharp.
  3. Always mark out and cut the mounts from the back of the mountboard.
  4. Think about it three times, measure it twice and cut it once.
  5. Ensure that the bevel is going to be the right way.
  6. Cut the mount on the top of a scrap mountboard or cutting mat.
  7. Mind your fingers !
  8. Always use a razor blade to finish any under cutting that may be needed.
  9. Mind your fingers !
  10. Never push the middle of the mount out because it will tear the board.
  11. If at first, you don’t succeed ......!

Exert from my book "Frames and Framing":

Do not cut deeper as you cut. Once at the stop point, keep the blade at the same depth as you had to begin with and then slide the mount cutter back to the start point. Move the blade slightly deeper. Then repeat the stages as above.

Useful Tips for Multi Aperture Mounts

Multi Aperture Mount

A Multi Aperature Mount

  1. Always draw a rough sketch with all dimensions shown
  2. If you make the border between the apertures smaller that the outside borders,this will look easier on the eye.
  3. Measure these points carefully and check your addition to avoid mistakes
  4. Draw the mount on the back of the board as usual
  5. Circle the points of intersection on the mounts, with a pencil, to make the shape clearer from the other lines.
  6. Make sure you have the mount cutter pointing the right way before cutting each line.
  7. Cut one hole at a time and remove the middle with a razor blade.
  8. For single mounts with one aperture, always have a greater width of mount at the base.

Exert from my book "Frames and Framing":

When measuring your multiple aperture mounts the bars between the pictures tend to look better if they are a lot narrower than the outer borders of the mount. A good measurement is to use ¾” – 1” or 20mm to 25mm for the bars between pictures. Any wider than this and the pictures can appear to be unrelated to each other.